Configuring Remote Peer
Question
Which command configures the remote peer when the Cisco IOS XR Traffic Controller is used?
Answers
Explanations
Click on the arrows to vote for the correct answer
A. B. C. D.D.
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-2/segment-routing/configuration/guide/b-segment-routing-cg-asr9000-62x/b-The Cisco IOS XR Traffic Controller is a feature that provides traffic management and control capabilities for service providers and large enterprises. When configuring the remote peer for this feature, there are several commands that can be used, but the correct command depends on the specific task being performed.
A. The "peer-sync ipv4" command is used to synchronize the configuration of peer routers in a group. This command is not used to configure a remote peer for the Cisco IOS XR Traffic Controller.
B. The "state ipv4" command is used to display the state of a peer router in a group. This command is not used to configure a remote peer for the Cisco IOS XR Traffic Controller.
C. The "peer ipv4" command is used to configure a remote peer for the Cisco IOS XR Traffic Controller. This command specifies the IP address of the remote peer router that will be used for traffic control.
D. The "state-sync ipv4" command is used to synchronize the state of peer routers in a group. This command is not used to configure a remote peer for the Cisco IOS XR Traffic Controller.
Therefore, the correct command to configure the remote peer when using the Cisco IOS XR Traffic Controller is "peer ipv4 <IP address>".
