Question 81 of 120 from exam 350-501-SPCOR: Implementing and Operating Cisco Service Provider Network Core Technologies

Question 81 of 120 from exam 350-501-SPCOR: Implementing and Operating Cisco Service Provider Network Core Technologies

Question

Rl#show ip ospf interface gig 2
GigabitEthernet2 is up, line protocol is up

Internet Address 172.20.1.12/31, Area 0.0.1.255, Attached via Interface Enable

Process ID 1, Router ID 10.255.255.1, Network Type POINT TO POINT, Cost: 1

Topology-MTID Cost Disabled Shutdown Topology Name

0 1 no no Base

Enabled by interface config, including secondary ip addresses

Transmit Delay is 1 sec, State POINT_T0_ POINT

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

Ri¢show ip interface gig 2
GigabitEthernet2 is up, line protocol is up
Internet address is 172.20.1.12/31
MTU is 9216 bytes

R2#show ip ospf interface gig 2
GigabitEthernet2 is up, line protocol is up

Internet Address 172.20.1.13/31, Area 511, Attached via Interface Enable

Process ID 1, Router ID 10.255.255.2, Network Type POINT TO MULTIPOINT, Cost: 1

Topology-MTID Cost Disabled Shutdown Topology Name

0 1 no no Base

Enabled by interface config, including secondary ip addresses

Transmit Delay is 1 sec, State POINT_TO MULTIPOINT

Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5

R2#show ip interface gig2
GigabitEthernet2 is up, line protocol is up
Internet address is 172.20.1.13/31
MTU is 1500 bytes

Refer to the exhibit.

While troubleshooting the OSPF adjacency between routers R1 and R2, an engineer noticed that both routers are stuck in the EXCHANGE/ EXSTART state.

What should the engineer fix to solve the ongoing issue?

Answers

Explanations

Click on the arrows to vote for the correct answer

A. B. C. D.

C.