Question 33 of 490 from exam 400-051: CCIE Collaboration

Q: Refer to the exhibit.A user is going through a series of dialing steps on an SCCP IP phone (extension 1001) to call another SCCP IP phone (extension 2003)Both phones are registered to the same Cisco Unified Communications Manager cluster.Which user inputs are sent from the calling IP phone to the Cisco Unified Communications Manager, in forms of SCCP messages, after the user pressed the Dial softkey? Note that the commas in answer choices below are logical separators, not part of the actual user input or SCCP messages.

A single SCCP message is sent to Cisco Unified Communications Manager to report that digits 2003 have been dialed.

Prev Question Next Question

Question

Refer to the exhibit.

SCCP IP Phone SCCP Messages
Extension 1001

Step 1: Phone is on-hook

Step 2: User presses 201, digit by digit

Step 3: User presses the "<<" soft key to deletes the last digit entered
Step 4: User enters the remaining digits, 03, digit by digit

Step 5: User selects the "Dial" soft key

SCCP IP Phone Extension 2003

A user is going through a series of dialing steps on an SCCP IP phone (extension 1001) to call another SCCP IP phone (extension 2003)

Both phones are registered to the same Cisco Unified Communications Manager cluster.

Which user inputs are sent from the calling IP phone to the Cisco Unified Communications Manager, in forms of SCCP messages, after the user pressed the Dial softkey? Note that the commas in answer choices below are logical separators, not part of the actual user input or SCCP messages.

Answers

A. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 0, 3.

B. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 1, <<, 0, 3.

C. A single SCCP message is sent to Cisco Unified Communications Manager to report that digits 2003 have been dialed.

D. A single SCCP message is sent to Cisco Unified Communications Manager to report that digits 201<<03 have been dialed.

E. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 1, <<, 2, 0, 0, 3.

Show Answer

Explanations

Click on the arrows to vote for the correct answer

A. B. C. D. E.

After the user delete phone stop the digit by digit dialing and send it as a whole setup.

Prev Question Next Question