Juniper Telnet Command

D

The command "telnet interface ge-1/1/0 10.10.10.1 source 192.168.100.1 bypass-routing" is used to initiate a telnet session from the Juniper device's interface ge-1/1/0 to the IP address 10.10.10.1, with a source IP address of 192.168.100.1 and bypassing the routing table lookup. Let's look at each statement to determine which one is correct.

A. The bypass-routing parameter is ignored when using private IP addressing. This statement is incorrect. The bypass-routing parameter is not specific to public or private IP addressing. It is used to bypass the routing table lookup for the source IP address, regardless of whether the address is public or private.

B. The telnet session will have the source IP address 10.10.10.1. This statement is incorrect. The "source" parameter specifies the source IP address for the telnet session, which is 192.168.100.1 in this case. The destination IP address is 10.10.10.1.

C. The telnet session will connect to the neighboring device's interface ge-1/1/0. This statement is correct. The "interface" parameter specifies the interface on the local device to use for the telnet session. In this case, the session will use interface ge-1/1/0 on the local device to connect to the neighboring device's interface ge-1/1/0.

D. Return traffic for the telnet session might not arrive at interface ge-1/1/0. This statement is correct. The "bypass-routing" parameter is used to bypass the routing table lookup for the source IP address. As a result, return traffic for the telnet session might not follow the same path as the outbound traffic and might not arrive at interface ge-1/1/0. This can happen if there are multiple paths to the destination, and the return traffic follows a different path than the outbound traffic.