Which Junos operational mode command is used to verify that load balancing is working as expected?
Click on the arrows to vote for the correct answer
A. B. C. D.D
The correct answer is C. show route balancing.
In Junos, load balancing is achieved through Equal Cost Multipath (ECMP) routing, which allows multiple paths to be used for forwarding traffic to a destination. When load balancing is configured, Junos uses an algorithm to distribute traffic across available paths.
To verify that load balancing is working as expected, the show route balancing command can be used. This command displays the next-hop paths that are being used to forward traffic to a particular destination. It also shows the percentage of traffic being sent over each path, allowing network operators to confirm that traffic is being distributed evenly across all available paths.
On the other hand, show route all and show route extensive commands display detailed information about all routes in the routing table, including their prefixes, next-hop IP addresses, and interfaces. These commands can be useful for troubleshooting routing issues but are not specifically designed for verifying load balancing.
The show route forwarding-table command displays information about the forwarding table, which is used by the router to determine how to forward traffic. This command can be useful for troubleshooting forwarding issues but is not specific to load balancing.
Therefore, the correct answer is C. show route balancing.