Which Tools Are Needed to Build Cat 6a Ethernet Cables?

A network technician receives a spool of Cat 6a cable and is asked to build several cables for a new set of Ethernet runs between devices.

Which of the following tools are MOST likely needed to complete the task? (Choose three.)

A.

Wire stripper

B.

Cable crimper

C.

RJ-11 connectors

D.

RJ-45 connectors

E.

Multimeter

F.

Punchdown tool

G.

Tone generator.

ABD.

To build Ethernet cables, several tools are necessary.

1. Wire stripper: This tool is used to strip the insulation from the end of the cable to expose the wires inside. It ensures that the correct amount of insulation is removed without damaging the wires.

2. Cable crimper: This tool is used to attach connectors to the end of the cable. It compresses the connector onto the wires, creating a secure connection.

3. RJ-45 connectors: These are the connectors that are commonly used for Ethernet cables. They have eight pins and are designed to fit into an RJ-45 jack.

4. RJ-11 connectors: These connectors are smaller than RJ-45 connectors and have only four pins. They are used for telephone cables and not suitable for Ethernet cables.

5. Multimeter: This tool measures voltage, current, and resistance in electrical circuits. It is not needed to build Ethernet cables.

6. Punchdown tool: This tool is used to terminate wires in a patch panel or a keystone jack. It punches the wire into place, creating a secure connection. It is not needed to build Ethernet cables.

7. Tone generator: This tool is used to trace cables by sending a signal through the cable and using a probe to detect the signal. It is not needed to build Ethernet cables.

Therefore, the three tools that are most likely needed to complete the task are wire stripper, cable crimper, and RJ-45 connectors.