How to Correct the Default Gateway Configuration for Cisco DNA Center Enterprise Interface

A.

None of the options listed in the question are correct for correcting the configuration of the default gateway for the Cisco DNA Center enterprise interface.

To correct the configuration of the default gateway for the Cisco DNA Center enterprise interface, the engineer needs to follow the below steps:

1. Log in to the Cisco DNA Center appliance via the console or SSH.
2. Enter the enable mode by typing 'enable' and the enable password.
3. Enter the configuration mode by typing 'configure terminal'.
4. Locate the IP address of the interface that needs to have its default gateway updated by typing 'show ip interface brief'.
5. Type 'interface <interface_name>' to access the interface configuration.
6. Enter the IP address of the default gateway for the interface by typing 'ip default-gateway <gateway_ip_address>'.
7. Exit the interface configuration mode by typing 'exit'.
8. Save the changes by typing 'copy running-config startup-config'.

Note that the interface name in step 5 may be different depending on the interface that needs to be updated. For example, if the interface that needs to be updated is the GigabitEthernet1 interface, the command would be 'interface GigabitEthernet1'.

It is important to note that the options listed in the question are not applicable for correcting the configuration of the default gateway for the Cisco DNA Center enterprise interface. The options listed appear to be related to the Maglev load balancing technology used by Google, and are not relevant to the Cisco DNA Center platform.